MIL-DTL-45195F (AR)
4.3 Conformance inspection.
4.3.1 Lot formation. Lot formation shall be in accordance with
lot formation requirement of MIL-STD-1916. In addition, each
inspection lot of the cartridge 105MM HE M1 shall contain:
a. Explosive of one type from one lot interfix number from one
manufacturer.
b. Projectile metal parts of one lot interfix number from one
manufacturer.
c. Loaded projectiles of one weight zone.
d. Supplementary charge of one lot interfix number from one
manufacturer.
e. Cartridge cases of one lot interfix number from one
manufacturer.
f. Propelling charges from not more than one lot.
g. Loaded primers of one lot interfix number from one
manufacturer.
h. Fuze well liners of one lot interfix number from one
manufacturer.
4.3.2 Classification of characteristics.
a. Sampling requirements. Inspection sampling requirements for
critical, major and minor characteristics are defined in MIL-STD-1916.
Unless specified otherwise, Inspection Level IV shall be used for all
characteristics defined as Majors and Inspection Level II for all
Minor characteristics; Critical characteristics shall be addressed in
accordance with MIL-STD-1916.
b. Conformance inspection. Conformance inspection shall be
performed in accordance with paragraph 4.3.2.1 through 4.3.2.14. For
all conformance inspections the same sample specimen may be used for
all non-destructive examinations or tests.
c. Alternative Inspections. Alternative conformance inspections
may be submitted and approved in accordance with MIL-STD-1916.
d. Tool control. Dimensions marked tool control shall be gaged
at the beginning of production and whenever tooling is replaced.
Where destruction of components is necessary to inspect these
dimensions, measurements of the tool may be substituted provided there
is an established correlation between the tool dimensions and the
component dimensions prior to the start of production. There shall be
adequate surveillance to assure that the drawing requirements are
being met throughout the life of the tool.
16
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business