MIL-DTL-60547G (AR)
be used for all characteristics defined as majors and inspection
level II for all minor characteristics; critical characteristics
shall be addressed in accordance with MIL-STD-1916.
b. Conformance inspection. Conformance inspection shall be
performed in accordance with paragraph 4.3.2.1 through 4.3.2.6.
For all conformance inspections the same sample specimen may be
used for all non-destructive examinations or tests.
c. Alternative inspections. Alternative conformance
inspections may be submitted and approved in accordance with MIL-
STD-1916.
d. Tool control. Dimensions marked tool control on dwgs.
10535878 and 12551740 shall be gaged at the beginning of
production and whenever tooling is replaced. Where destruction
of components is necessary to inspect these dimensions,
measurements of the tool may be substituted provided there is an
established correlation between the tool dimensions and the
component dimensions prior to the start of production. There
shall be adequate sampling to assure that the drawing
requirements are being met.
12
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business